Air Filter Relocation. Overview. Relocating your Air Filter is one of the most important steps when installing your HornBlasters kit. If you are mounting your compressor outside the vehicle, chances are it's going to get wet at some point in its life
Getting Ready for the Install. You have been waiting patiently for your kit to come in the mail. Your boxes finally come in and you can’t wait to get your horns on and take them through the neighborhood for a test run. As bad as you want to get it on
Assembling the Air Tank. The Finished Product. Getting Started. Let's start with the assortment of fittings that came with your Conductors Special kit. Your 2-gallon air tank has six ports available for use for our kit. The two 1/2" ports on the end-
Connecting the Shocker Horns to the Air Tank. Getting Started. Your horn kit came with the assortment of fittings below. Let's start by plumbing one of the two 1/2" NPT x 1/2" PTC (D) fittings into the tank. If you are using a 2-gallon tank, this fit
Step-by-step guide for installing a pressure switch with a separate 40A relay.
Using the Steering Wheel to Honk our Horns. Overview. At a glance, this sounds like a very difficult task to complete. Digging into the steering wheel/column is not easy. Thankfully, we don't have to in order to use our horns. In this guide, we will
Using a Push Button. Getting Started. Using a standard on/off push button to honk your horns with is very easy to do. To start, we will need our push-button, a roll of 18awg wire, and a few crimp connectors. These parts are pictured below. The Push B